Start slideshow
(NOV05) A simple project that wound up having an "X factor" of about 5. The 2x4 wheel supports you see on the base of the tablesaw were a bad design to start…
So here are a few shots of the 2+ day "small project". In order to remove the factory saw stand I had to jack the whole thing up and then remove the base from…
The frame is finished (which took most of the two days). That probably seems like a long time for such a simple task but without the benefit of a saw that can…
Due to the new design, the finished base was now taller and wider than the original and that made it a real pain to get the very heavy saw/table combo back on…
Finally, a shot of the new base installed on the saw.